Is your site a candidate for Solar?
Find out with a Free Site Evaluation
1-87-SOLAR-888 | EMAIL
Top of the Line Components
Canadian Solar has a much stronger frame than other modules passing mechanical load test of 5400Pa, instead of the normal 2400Pa, to withstand heavier snow load and higher wind-pressure.
Canadian’s also have a power tolerance of +/-2.5% vs other modules which have +/-5%.
Canadian Solar is the 1st manufacturer in PV industry to apply ISO:TS16949 (The automotive quality management system) in module production.
Canadian Solar provides the solar industry with the widest PV product lines from 0.03W to 300W.
Canadian Solar is a global company offering customized PV products and OEM services around the world.
The Sunny Boy “US” series of string inverters have been updated with the most advanced technology and are designed specifically to meet the new IEEE 1547 requirements.
Their compact design makes them ideal for light commercial or residential use and the integrated DC disconnect makes installation more cost-effective. Increased efficiency means better overall performance and shorter payback periods. Each are engineered and built to last and now come with a standard ten year warranty. Sunny Boy inverters are trusted worldwide to go the distance.
- CEC efficiency of up to 96%
- 10 Year warranty standard, up to 20 years optional
- Certified to the new UL 1741/ IEEE 1547
- Integrated load-break rated DC disconnect switch
- Integrated fused series string combiner
- Sealed electronics enclosure and OptiCool
- Comprehensive SMA communications and data collection options
- Ideal for residential or light commercial applications
- Rugged cast aluminum outdoor rated enclosure
SAFE: All parts related to the mounting systems manufactured by Professional Solar Products are designed and engineered for safety and reliability over time. A large factor in why all mounting systems utilize an open C-channel is to allow water to flow through without becoming trapped. This is extremely important in colder climates such as in the North East where trapped water can promote freeze damage. The C-channel rail and all splice accessories are designed to prevent this. The Roof Trac mounting system is load tested for snow load along with a high wind aperture (125mph) and has been successfully installed in the northeast and southwest, including Hawaii, since 1999. Load testing not only proves in a real world setup that the system will remain on the roof during these conditions, but that the modules will remain in the frame under extreme load.
AESTHETICALLY PLEASING: All hardware and connections are concealed within the C-channel support rail. The innovative support channel when incorporated with the Slide-n-Clamp system (as explained below) provides structural support at a lower profile to the roof. All exposed vertical surfaces are flat and smooth - there are no pockets or grooves to trap dirt, debris or moisture which causes corrosion.
EASY TO INSTALL: Holes are easily drilled in the support channel by using a #10 UniBit drill bit (it takes less than 3 seconds per hole). The bottom of the support rail contains a specially extruded "V-groove" to facilitate perfect centering of the hole. Top-down clamps are easy to install using the sliding channel nut
